Random good picture Not show

31. Through the analysis of the local strain concentration or stress concentration, together with the forming ability model, the occurrence and location of the crake can be predicted.

32. In addition, the stress concentration caused by improper machining was also the reason of fracture.

33. The factors of stress concentration in thin plates used as springs in electric switches were required.

34. An Account to enable stress positions, reduce local stress concentration.

35. Conclusion Stress concentration of the spine may be implicated in the biomechanical mechanism underlying thoracolumbar burst fractures.

36. The amplitude and gradient of MMMT signals not only relied on the average stress of the shell, but also relied on the local stress concentration.

37. The influences of different loads on hole - edge stress concentration factors were discussed.

38. Numerical results for the dynamic stress concentration factors plate with a circular hole are given.

39. As found in Example 1, the stress concentration factor for the fillets is equal to 1.78.

40. Results Stress concentration was noted at the pedicle and posterosuperior part of the vertebral body near the pedicle.

41. With the increase of notch root radius and the decrease of stress concentration coefficient, the tensile strength decreased.

42. The tangent frost heaving stress will generate stress concentration at the pile defects, thus damaging the pile body.

43. Secondly, the left arch and the right arch spring generate the regions of stress concentration for the shear strain distinctly increasing.

44. The experimental results show that both the depth and the radius exert an influence on the stress concentration at the groove bottom remarkably, and the influence of the flare angle can be neglected.

45. The crack appears at the edge angle due to stress concentration caused by alternating load, which finally leads to the fissuring of die plate.

46. Experiments showed that it is possible to test the stress concentration with the above mentioned method.

47. The stress concentration factor of any notched specimen can be calculated using these formulae with high precision, less error as only 1 and convenience in use.

48. The round, arch wall and hemicycle were with the obvious stress concentration at the top of chamber,[http://sentencedict.com/stress concentration.html] close to point of concentration.

49. In this paper, multi - scale RKPM is reviewed and applied to stress concentration problems.

50. Furthermore, calculations of stress concentration coefficient for both eccentric and concentric reducers are completed.

51. Scattering of SH - wave and dynamic stress concentration problem are investigated by U - shaped cavities in half space.

52. The result shows that the stress concentration caused by eccentricity and deflection located in a smail part near the transition region.

53. If transition a circular shaft adopting closed angle will bring biggish stress concentration as bearing load.

54. The results show that high stress in serration and its arc transition region, and observed that severe stress concentration in these locations.

55. Scattering of flexural waves by multiple cutouts and dynamic stress concentration in the thin plates were investigated in terms of the complex variable function method and multi-polar coordinates.

56. It pointed out that the design of gear cutter should greatly increase the tooth point arc so as to reduce the stress concentration to increase the force of tooth root.